67 Engine Wiring Harness w/Headlight Harness
Item #:
E-214
$349.99
In Stock - Ships today if ordered by 3pm ET
-
+
Related To This Item

New reproduction 1967 Corvette engine and headlight wiring harness. Engine/headlight harness attaches to back of fuse panel and connects to headlight bucket extension, headlight motors, park lamps connection and horns. The harness also connects to engine components including ballast resistor, coil, temperature sender, voltage regulator, alternator, starter and blower motor. Fits all 1967 Corvettes.

Note: Requires use of headlight bucket extensions to comple installation to headlight bulbs.

Factory harnesses originally supplied with your Corvette had a 10 year service life. How old is your Corvette's wiring? 20, 30, maybe 40+ years. Original harnesses were made with copper strand housed in plastic. Over time the plastic deteriorates, becoming brittle and cracked, allowing moisture to get into the wire, which in turn causes the copper to begin corroding. Corroded wires lead to short circuits with the possibility of an electrical fire. Why gamble on the condition of an old harness to save a few bucks?

Zip Corvette provides the Corvette owner with the most correct wiring harnesses available. All harnesses are hand assembled in the USA, guaranteed to fit. Harnesses feature correct wires that match factory color codes and gauge size, but are made with Cross Linked Polyethylene type GXL wire which is much more tolerant to heat than the original PVC type GPT wire. Connections are dip soldered (where applicable) to eliminate resistance loss and feature reproduction connectors and terminals. All harnesses are wrapped with correct non-adhesive or cloth woven tapes to assure a 100% factory appearance.

This item is proudly Made in the USA

Model Years

More Information
Generation C2
Model Year 1967
Write Your Own Review
You're reviewing:67 Engine Wiring Harness w/Headlight Harness
Your Rating
Copyright © 2019, Zip Products Inc All rights reserved.